Polywin Polybest Flostar

( Khandelwal Cables Ltd.,) (Khandelwal Associates ) (Flostar Wires )

Miniaturised Winding Wire for Submersible Pump Motors.

These Winding Wires having an outstanding Electrical, Mechanical, Thermal & Chemical properties. These are quite sturdy, robust and minaturised too. These are not only fulfil the requirement of all available standards but even more better in many respects. These winding wires can withstand water abrasion and frictional losses, saves space/size, cost and work in every type of typical conditions. In brief the details are as follows :

HIGH TEAR RESISTANT : The structure of insulation is oriented bi-axially. Propagation of tears is difficult. Uniaxial orientation makes it easy to tear the insulation along the axis of the wire.

HIGH DIELECTRIC STRENGTH : The multiple layer construction of Polywin insures high dielectric quality of insulation. Any flaw is limited to a single layer of the tape. The wrapping process places the insulation concentrically around the conductor.

HIGHER CUT THROUGH & ABRASION RESISTANT : Polywin insulation is remarkable resistant to cut through and scrap abrasion. Thin cross sections of Polywin 0.15mm to 0.25mm thick will endure greater cut through stress and general abuse than 0.25mm to 1.0mm of insulation such as PVC, Nylon Jacketed PVC.

HIGH INSULATION RESISTANCE : It has remarkable constant & thousands time higher insulation resistance even at boiling point of water than PVC.

HIGH TENSILE STRENGTH : Polywin insulation adds significantly to the tensile strength of the insulated conductor through the mechanics of load transfer because the insulation has such a superior breaking strength. It will support the wire at each point where excessive stretching occurs. Wire insulates with conventional materials will break since there is no support from insulation.

HIGHER FLEX LIFE : The insulation is produced by bi-axially oriented synthetic films. It has very high flex life in comparison to any other insulating materials.

WORKING TEMPERATURE : For short periods +130 0C. Continuous -60 0C to +120 0C.

SIZES : 0.4mm to 6.0mm (Single-solid), 4.0Sq.mm to 50Sq.mm (Multistrand).

INSULATION THICKNESS : 0.10mm to 0.50mm ( as per customer's requirements)

INDIAN STANDARD : IS:8783 - 1995.

 

Polyflon - PTFE insulated Winding wire for 250 0C and for any chemical or oil filled pumps. Other details are as above.

We are capable to develop any kind of insulated winding wire for Submersible motor pumps. In case, if you require any other type of winding wire please contact us.